Panasonic WJ-SX 150 - Manual (Page 121)

125
This section will describe what you should take notice when using a PS·Data system controller.
The same descriptions as the system controller's operating instructions are not mentioned here. Refer to them.
Refer the descriptions of terminal mode for illustrations.
■ Controlling the Recorder with a PS·Data System Controller
● Recorder Mode
Before operating the recorder, it is necessary to enter the recorder mode.
1. Select the desired monitor. (Refer to p. 109 Monitor Selection.)
2. Enter "111" by pressing the numeric button.
"111" will appear on the LED display.
3. Press the CAM button.
The recorder image will be displayed on the selected monitor, and you will enter the recorder mode.
4. Enter the desired function code, and then press the FUNCTION button. (Refer to the diagram.)
5. To select a camera channel, press the numeric button(s), then CAM button. The system will exit from the recorder mode,
and the selected camera image will be displayed on the monitor.
Notes:
• Only one operator can enter the recording mode.
• The images from the recorder, which are displayed on the monitor, is conformed to the recorder setting.
Exclusive use to stop playback
WJ-HD100 SERIES CONTROL (PS·DATA)
Function Code Note
Forward field advance 1
Backward field advance 2
Pause 4
Playback 5
Recording 6 Equal to the REC button of the recorder
To the first field 7
Stop recording and playback 8
Stop playback 9
Stop recording 10 Exclusive use to stop recording
Search forward
Search backward
11
12
To the last field 3