Panasonic WJ-SX 150 - Manual (Page 56)

58
• MUX MOTION DET
This menu appears only when the Multiplexer board is
installed in the unit.
This stands for that the unit’s motion detector is activat-
ed when a camera detects the brightness-level change
and transmit an alarm signal.
ON: The alarm-associated sequence/spot image is dis-
played on a monitor, and alarm recording will start
(if a recorder is connected to the unit.)
REC ONLY: Only alarm recording will start and moni-
tors will keep displaying the current sequence/spot
images.
Note: You cannot recover alarm-related operations
from system controllers when REC ONLY is
selected.
OFF: An alarm input is not accepted by the motion
detector.
To configure where to activate the motion detector, set
MUX MOTION DET to ON or REC ONLY, and press the
CAM (SET) button. The live image will be displayed.
Note: Black image will be displayed on the monitor if
the currently selected channel has no camera con-
nection.
A “+” mark appears at the center of the monitor.
The following is the setting procedure.
1. Move the cursor with the joystick to the desired area,
and then press the CAM (SET) key. Setting point 1 is
determined.
2. Move the “+” mark to the desired area, and then press
the CAM (SET) key. Setting point 2 is determined and
the “+” mark will disappear. Then, the mark will appear
again at the center of the monitor. The square, covered
with Setting point 1 and 2, is showing the motion-detec-
tion area.
Note: White images will be displayed in the square if the
currently selected channel has no camera connection.
3. To configure more motion-detection area, repeat Step 1
and 2.
Up to 4 motion-detection areas are available.
+ Mark
+
Setting point
+
Setting point 1
Setting point 2
+