Monitor selection and camera selection, Monitor selection, Priority lock – Panasonic WJ-SX 150 User Manual

Page 88: Applying priority lock, Releasing priority lock

Advertising

■

Priority Lock

●

Applying Priority Lock

1. Select the desired monitor. (Refer to Monitor Selection).

2. Press the MON (ESC) button while holding down the

SHIFT button to toggle the priority lock mode on and off
on the active monitor.
If the priority lock mode is selected, the monitor number
will inversely appear on the active monitor as shown in
the figure.

Note:

This function will prevent operators with lower priority

from gaining control of a monitor.
However, higher or equal priority operators may still
gain control of the monitor.

M04

SHIFT

PAUSE

TOUR SEQ

PAUSE

MON LOCK

DEF ON

WIPER

DEF OFF

MON (ESC)

T&D

CAM ID

MON STATUS

ALL

EVENT

ALM H

VLD H

SYS S

CAM (SET)

MULTI SCREEN SEL

SEQUENCE

AUX2 ON

AUX2 OFF

EL-ZOOM

AUX1 ON

AUX1 OFF

STILL

●

Releasing Priority Lock

1. Select the desired monitor. (Refer to Monitor Selection.)

2. Press the MON (ESC) button while holding down the

SHIFT button to release the priority lock mode.
The monitor number returns to the normal display on
the active monitor.

After the log-in procedure, the following operations are
available to control the system.
The operation begins with selecting a monitor, then the
selected camera appears the active monitor.

■

Monitor Selection

1. To select the desired monitor number (1 to 4), press the

numeric button.

2. Press the MON (ESC) button to execute the selection.

The MONITOR indicator on the controller will light up
and the selected monitor number will appear on the
LED display of the controller.

3. If the selected monitor number is not valid, the PROHIB-

ITED indicator lights up and the number on the LED dis-
play will blink for approximately 3 seconds.
Return to step 1 and select a new monitor number.