Panasonic AG-3DP1G - Manual (Page 111)

111
Chapter

Men
u
Oper
ations
Item Setting Notes
MASTER PED Adjusts the black master pedestal that serves as the
video reference.
–100 ... +15 ... +100
• Hold down the JOG dial button and
turn it downwards or upwards and
maintain this position to quickly
change values.
• When a remote control unit (AJ-
RC10G) or extension control unit (AG-
EC4G) is connected, use the M-PED
control on the remote control unit or
extension control unit to adjust.
A. IRIS LEVEL Sets the AUTO IRIS target value.
–10 ... 0 ... +10
GAMMA Selects the gamma curve.
HD NORM:
Gamma setting for HD recording.
LOW: Applies a gently rising gamma curve to low-
brightness areas for a balanced look.
HIGH:
Applies a steep gamma curve to low brightness
areas to expand the tonality of dark areas for video
with greater brightness. Contrast softens as a result.
B.PRESS:
Produces sharper contrast than LOW.
CINE-LIKE D:
Applies a gamma curve to produce
video with a cine-like feel.
CINE-LIKE V: Applies a gamma curve to produce
high-contrast video with a cine-like feel.
• A lens aperture set lower than normal video level
(approx. 1/2) is recommended when using cine-like
gamma to enjoy the full benefit of the function.
KNEE Sets the compression level (knee point) of the high
brightness video signals received through the MOS
sensor to avoid overexposure.
HIGH: High setting (compression starts at approx.
100 %)
MID:
Medium setting (compression starts at approx.
90 %)
LOW: Low setting (compression starts at approx.
80 %)
MATRIX Selects the MATRIX table to reproduce color during
shooting.
NORM1:
Ensures proper color rendition when shooting
out in the open or under halogen lighting.
NORM2:
Produces more vivid colors than NORM1.
CINE-LIKE:
Produces a tone similar to movie film.
NAME EDIT Edits the name of the selected scene file. • No names are set for FILE1 to FILE 6
with the factory default settings.
SYSTEM SETUP Screen
Item Setting Notes
SYSTEM MODE Specifies the signal format used by this camera.
1080-59.94i, 1080-23.98PsF, 720-59.94P, 1080-50i,
720-50P
• When a setting is changed, the message “TURN
POWER OFF” appears. Then turn the power off and
turn it back on again.
• The factory default setting is 1080-50i
when the area setting is PAL.
____ indicates the factory setting