Panasonic AG-3DP1G - Manual (Page 130)

130
Chapter

Maintenance
and
Inspections
Warning and Error Display for Thumbnail Operation
Item Message Description Measure
Thumbnails
CANNOT ACCESS!
Data cannot be accessed because it is
corrupted or for other reasons. Restore media and clips to normal state
before access.
CANNOT DELETE !
P2 card contains contents version
mismatches or bad clips. Match devices and contents versions, and
repair bad clips.
CANNOT FORMAT!
Formatting cannot be made due to some P2
card problem.
Check the P2 card.
CANNOT REPAIR!
Data cannot be repaired since content that
cannot be repaired is selected.
Check selected content.
CANNOT REPAIR IN
SELECTION! Some of the selected clip could not be
repaired.
—
CARD FULL! The P2 or SD card is full. Insert media with sufficient capacity.
INVALID VALUE! Entered data was invalid. Enter data in a valid range.
LACK OF CAPACITY!
The recording capacity on the P2 card is
insufficient. Insert a card with sufficient recording
capacity.
MISSING CLIP!
You tried to add a shot mark to a clip that had
been recorded across multiple cards, using
another 3D device.
Any clip recorded across multiple cards is
not supported.
NO CARD! No P2 or SD card is inserted. Insert compatible media.
NO FILE! The designated file is not found. Check the file.
NO SD CARD! No SD card is inserted. Insert an SD card.
TOO MANY CLIPS! Too many clips are selected. Reduce the number of selected clips.
UNKNOWN
CONTENTS FORMAT! P2 card contains contents version
mismatches or corrupted content.
• Match devices and contents versions.
• If corrupted clips exist (including
corrupted clips that are located on the
copy destination), repair the corrupted
clips or delete them.
UNKNOWN DATA! The metadata character code is invalid.
Use UTF-8 for the metadata character
code. Use the viewer to enter correct
characters.
USER CLIP NAME
MODIFIED! Characters in the clip name had to be
deleted in adding the counter value.
The user clip name plus the counter
value can only contain up to 100
bytes. Characters in the clip name are
automatically deleted when the total
exceeds 100 bytes.
WRITE PROTECTED! The P2 or SD card is write protected. Insert write-enabled media.
Soft
keyboard CANNOT SET! INVALID
VALUE!
The entered value is incorrect. Change the value.