Panasonic AG-3DP1G - Manual (Page 46)

4
Chapter
4

Adjustments
and
Settings
for
Recording
Adjusting the White Balance and Black Balance
To record high-quality video with the AG-3DP1, the black
and white balances must be adjusted according to
conditions.
For higher quality, it is recommended that the adjustments
should be made in this order AWB (white balance
adjustment)  ABB (black balance adjustment)  AWB
(white balance adjustment).
 NOTE
If white balance and black balance adjustments are made
while the video image is distorted due to GENLOCK, the
adjustments may not be correct. Wait for the video image
to return to normal before performing white balance and
black balance adjustments again.
Adjusting the White Balance
Whenever light conditions change, the white balance must
be readjusted.
To adjust the white balance, follow the steps below.
c
d
e b
a
a ND FILTER buttons
These buttons adjust the amount of light entering the
MOS sensor.
b AUTO W/B BAL switch
Use for automatic control of white balance.
c GAIN selector switch
Normally set to 0 dB. If this is too dark, adjust gain as
necessary.
d OUTPUT selector switch
Set to CAM.
e WHITE BAL switch
Set to A or B.
f CONV. dial
Use to adjust the convergence.
1
 SettheGAIN,OUTPUTandWHITEBAL
switches.
2
 AdjusttheNDfilterwiththeNDFILTERbuttons
accordingtothelightingconditions.
For examples of the settings with the ND FILTER
buttons, refer to [Shooting and Recording/Playback
Functions Section] (page 19).
3
 Placeawhitepatternatapointwherethe
lightingconditionsmatchthoseforthelight
sourceofthesubject.Thenzoom-inonthe
whitepatternsothatwhitecolorappearsinthe
screen.
• A white object (cloth or wall) may be used instead
of a white pattern. The illustration below shows the
required size for the white space.
 NOTE
• Do not point the camera at a high-brightness area.
• The white object must appear at the center of the
screen.
1/3ormoreofthescreeninwidth
1/3ormoreofthe
screeninheight
4
 TurntheCONV.dialsothattheconvergence
point(referenceplane)issetonthewhite
pattern.
5
 Adjustthelensiris.
• Use the Y GET function (for details, refer to
page 50) and adjust the iris to a approximately
70 % of incoming light.
6
 TurntheAUTOW/BBALswitchtowardAWB
andreleaseit.
• The switch returns to the central position with the
white balance automatically adjusted.
7
 Duringanadjustment,theLCDmonitorandthe
viewfinderdisplaythefollowingmessage:
AWB Ach ACTIVE
f