Panasonic AG-3DP1G - Manual (Page 23)

3
Chapter

P
ar
ts
and
their
Functions
20 HD SDI OUT 1 (L) connector (BNC)
21 HD SDI OUT 2 (R) connector (BNC)
This connector outputs HD SDI signals.
When the menu option SDI OUT in the OUTPUT SEL
screen is set to ON, the HD SDI 1 (L) connector outputs
the left-lens (L) image, and the HD SDI 2 (R) connector
outputs the right-lens (R) image.
When the menu option SDI OUT in the OUTPUT SEL
screen is set to ON (SIDE), the HD SDI 1 (L) and HD
SDI 2 (R) connectors output the SIDE by SIDE image.
 NOTE
For HD SDI signals, use a double-shielded BNC cable 5C-
FB or higher.
22 HDMI connector
This connector outputs HDMI signals.
To output signals from this connector, set the menu
option SDI OUT in the OUTPUT SEL screen to OFF.
You can set character superimposition for output from
HDMI with the menu option HDMI OUT CHAR in the
OUTPUT SEL screen.
 NOTE
• Use HDMI cables (optional) with double shield or more.
• Use of Panasonic HDMI cables is recommended.
• The HDMI connector of this product is not compatible
with VIERA Link.
• When a VIERA-Link device is connected to this product
with an HDMI cable, VIERA Link of the connected device
may not operate properly.
23 HD SDI MONITOR OUT connector (BNC)
This connector outputs images for the monitor.
According to the menu option MON OUT SEL in the
OUTPUT SEL screen, images independent of HD SDI
OUT can be output.
You can set character superimposition for output from
HD SDI MONITOR OUTPUT with the menu option MON
OUT CHAR in the OUTPUT SEL screen.
 NOTE
For HD SDI signals, use a double-shielded BNC cable 5C-
FB or higher.
24 REMOTE connector
Some functions can be remote controlled when the
remote control unit AJ-RC10G (optional accessory) is
connected to the camera.
For details, refer to [Connecting the AJ-RC10G Remote
Control Unit] (page 121).
Some functions can also be remote controlled when the
AG-EC4G extension control unit (optional accessory) is
connected.
For details, refer to [Connecting the AG-EC4G
Extension Control Unit] (page 122).
25 RETURN IN (HD SDI) connector (BNC)
This connector inputs return video signals (HD SDI
signals) to allow checking the video on the LCD monitor
and in the viewfinder.
 NOTE
• For HD SDI signals, use a double-shielded BNC cable 5C-
FB or higher.
• The input signal of the RETURN IN connector can be
locked externally if the menu option GENLOCK SEL in
the OTHER FUNCTIONS screen is set to RETURN IN.