Panasonic AG-3DP1G - Manual (Page 115)

115
Chapter

Men
u
Oper
ations
Item Setting Notes
AUTO LEVEL CH3 Selects the method for setting CH3 level.
ON:
Engages the auto adjustment mode. The limiter is
not available.
OFF: Locks the level. The limiter operates on all inputs
except the line input of the rear.
AUTO LEVEL CH4 Selects the method for setting CH4 level.
Same setting as AUTO LEVEL CH3.
ON
TEST TONE Selects the test signal.
NORMAL:
Outputs test tones to channels 1, 2, 3 and
4 when the OUTPUT/AUTO KNEE selector switch is
set to BARS and the AUDIO IN switch CH1 is set to
FRONT.
ALWAYS:
Outputs test tones to channels 1, 2, 3 and
4 at all times when the OUTPUT/AUTO KNEE selector
switch is set to BARS.
CHSEL:
Outputs test tones to channels selected by
setting the AUDIO IN switch CH1 or CH2 to FRONT
and the OUTPUT/AUTO KNEE selector switch is set to
BARS. (Test tones are not output to CH3 and CH4.)
OFF:
Does not output a test tone.
F.MIC POWER Turns on and off the phantom power supply for the
front microphone.
ON, OFF
R.MIC POWER Turns on and off the phantom power supply for the
rear microphone.
ON:
Turns on the phantom power supply to the
microphone when the rear MIC/LINE selector switch is
set to MIC and the +48V ON/OFF switch is set to ON.
OFF:
Does not supply phantom power to the
microphone even when the rear MIC/LINE selector
switch is set to MIC and the +48V ON/OFF switch is
set to ON.
MONITOR SELECT Switches the output signal to earphones and speaker
when the MONITOR SELECT switch is set to ST.
STEREO, MIX
F.MIC LEVEL Selects the input level for the front microphone.
–40dB, –50dB
R.MIC CH1 LEVEL Selects the input level for the rear microphone
connected to CH1.
–50dB, –60dB
R.MIC CH2 LEVEL Selects the input level for the rear microphone
connected to CH2.
–50dB, –60dB
R.LINE LEVEL Selects the input level for the rear line input.
+4dB, 0dB, -3dB
HEADROOM Sets the headroom (standard level).
18dB, 20dB
• The factory default setting is 18dB
when the area setting is PAL.
WIRELESS WARN Sets whether a warning should be output when
wireless receiver reception is poor.
ON, OFF
WIRELESS TYPE Selects wireless receiver type.
SINGLE:
1-channel receiver
DUAL: 2-channel receiver
• When DUAL is selected for a 1-channel wireless
receiver, CH2 and CH4 will stay mute.
____ indicates the factory setting