Panasonic AG-3DP1G - Manual (Page 21)

1
Chapter

P
ar
ts
and
their
Functions
15
4 5 6 7
8
25
14
24 23
16 17 18
11 13 12 9 10
19 20 21 1 3
22 2 1
 Shooting and Recording/Playback
Function Section (Recorder Unit)
1 REC button
Press this button to start recording and press once
again to stop it.
The REC selector switch can be used to disable the
REC button on the handle.
2 REC switch
Switches functions of the REC button on the handle.
ON:
Enables the REC button.
OFF:
Disables the REC button.
3 RET/REC CHECK button
Press this button to play back the last two seconds of
the most recently recorded clip.
 NOTE
Only the POWER button is enabled during REC CHECK.
4 t REW (rewind) button
In stop mode, press this button for fast-reverse
playback.
During playback, press this button for fast-reverse
playback at about 4x normal speed.
If this button is pressed when playback is paused, the
beginning of the clip being played is located in pause
mode (cue-up mode).
5 g STOP button
Press this button to stop playback.
You can also press this button to stop interval recording.
6 y FF (fast forward) button
In stop mode, press this button for fast playback.
During playback, press this button for fast playback at
about 4x normal speed.
If this button is pressed when playback is paused, the
beginning of the next clip is located in pause mode
(cue-up mode).
7 PLAY/PAUSE button
Press this button to view playback on the LCD monitor
or in the viewfinder, or on a color video monitor.
Press it during playback to pause playback.
8 OUTPUT CHARACTER switch
Use this switch to control the superimposition of
character data onto HD SDI MONITOR OUT to indicate
status or setting menus.
ON:
Superimposes characters.
OFF: Does not superimpose characters.
9 P2 card slot (L, R)
Insert the P2 card for the left image into card slot L
(upper slot), and the one for the right image into card
slot R (lower slot).
For details, refer to [Inserting P2 Cards] (page 30).
10 P2 card eject button
Raise this button and press it to remove a P2 card.