Panasonic AG-3DP1G - Manual (Page 119)

11
Chapter

Men
u
Oper
ations
Item Setting Notes
USER FILE Reads/writes user files (files other than SCENE FILES)
from/onto the SD memory card.
FILE SELECT:
Selects user files (1 – 4).
READ:
Reads the user file (1 – 4) settings stored on
the SD memory card.
WRITE:
Saves the current user file (1 – 4) settings to
the SD memory card.
TITLE RELOAD:
Reloads title list.
SD CARD FORMAT Formats SD memory cards.
3D ASSIST Screen
Item Setting Notes
OUTPUT SEL Sets where to output the effect of 3D assist function
controlled by the 3D ASSIST buttons (Z WFM/ALERT/
CONV.).
LCD:
The effect of the 3D assist function is output to
the LCD monitor only.
LCD/EVF:
The effect of the 3D assist function is output
to the LCD monitor and viewfinder.
NEAR LEVEL Selects the alert level for a short distance in the 3D
assist function.
0.5%, 1%, 1.5%, 2%, 2.5%, 3%, 3.5%, 4%
• Use this item to set a guide for
safety shooting, preventing forward
divergence.
FAR LEVEL Selects the alert level for a long distance in the 3D
assist function.
0.5%, 1%, 1.5%, 2%, 2.5%, 3%, 3.5%, 4%
• Use this item to set a guide for safety
shooting, preventing backward
divergence.
DETECTION RANGE Selects the detection range of the 3D assist function.
NARROW: 6.56 % (1080)
WIDE:
13.12 % (1080)
• Use this item to prevent excessive
separation due to backward
divergence.
Z WFM SCALE Selects the display mode of the 3D assist function.
NORMAL:
Displays all the detection area.
2 x :
Displays a clip in half the detection area.
OTHER FUNCTIONS Screen
Item Setting Notes
USER FILE Saves user files to camera memory, loads them into
camera memory or initializes them. (For details, refer
to page 78, 107.)
LOAD, SAVE, INITIAL
• This does not affect options in the
SCENE FILE screen.
• The TIME ZONE setting is not
initialized.
ACCESS LED Determines whether or not the P2 card access LED
should light.
ON, OFF
ALARM Sets the alarm sound output when an alarm occurs.
HIGH, LOW, OFF
REC TALLY Selects the recording status indicator of the camera.
RED: Red tally lamp lights.
GREEN:
Green tally lamp lights.
OFF:
The tally lamp does not light.
EVF BAT LED Selects whether the BAT lamp inside the viewfinder is
to light or not when the remaining battery capacity is
below NEAR END.
ON, OFF
CLOCK SETTING Sets the internal calendar (date)
For details, see [Setting Date and Time of Internal
Clock] (page 28).
____ indicates the factory setting