Panasonic AG-3DP1G - Manual (Page 127)

1
Chapter

Maintenance
and
Inspections
Warning System
Warning Description Tables
If a problem is detected immediately after the power is turned on, or during operation, this will be indicated by the
WARNING lamp, lamps on the LCD monitor and a warning tone.
Warnings have priorities. If multiple errors occur simultaneously, the WARNING lamp, warning display on the screen, and
alarm tone are displayed in order of priority shown in the table below.
Priority
Warning
type
LCD indication Tally lamp
WARNING
lamp
Alarm
tone * 1
Warning description
and recording/playback
operation
Countermeasures
1 System error
SYSTEM ERROR cause
indication
* 2 blinks red.
Blinks 4
times per
second Blinks 4
times per
second
Continuous
tone
Reference signal or
communication error.
Operation stops.
Check the cause
indication
* 2
and consult your
distributor.
2
Incorrect
P2 card
removal
TURN POWER OFF
Blinks red
Blinks 4
times per
second Blinks 4
times per
second
Continuous
tone
A P2 card was removed
during access and card data
was corrupted.
Both P2 card access LEDs
blink in orange. Recording/
playback cannot start.
Turn off the power.
Repair the P2 card if
the clips on the card
are corrupted.
3
The
battery is
exhauseted
LOW BATTERY blinks
red, and the battery level
bar blinks with the empty
status. (This indication
appears even if CARD/
BATT is set to OFF in the
DISPLAY SETUP screen.)
Blinks 1 time
per second
Lights
Continuous
tone
The battery is exhausted.
Recording and playback
stop. The camera stops
automatically when the
voltage drops.
Replace the battery.
4
Version
mismatch
VERSION MISMATCH
PLEASE UPDATE
Blinks white Blinks 4
times per
second Blinks 4
times per
second
No
Version misatch has occurred.
Only SD CARD FORMAT and
UPDATE are available with the
thumbnail menu.
Perform CARD
UPDATE.
5
High
Temperature
error
detectionl
HIGH TEMPERATURE
Blinks red
Off Off No
High temperature error
is detected. Operation
continues, but abnormal
recording/playback may
occur.
Stop operation
immediately
and consult your
distributor.
6 Fan stop
FAN STOPPED cause
indication
* 3 blinks red
Off Off No
The fan is in failure and has
stopped. Although operation
continues with the fan
stopped, it may raise the
temperature inside the unit,
causing abnormal recording/
playback.
Check the cause
indication
* 3 and
consult your
distributor.
(Continued on the next page)
* 1 When the alarm sounds, audio is not output to the camera speakers or earphones. The DISP/MODE CHK button
cancels only the alarm tone when pressed during an alarm.
* 2 P2 SYSTEM ERROR cause indication
• P2 MICON ERROR: The P2 microprocessor does not respond.
• P2 CONTROL ERROR: A P2 recording control error has occurred.
• CAM MICON ERROR: The camera microprocessor does not respond.
• P2 MICON LINK ERROR: A connection error between P2 microprocessors has occurred.
* 3 FAN STOPPED cause indication
• FAN: FAN error position (1, 1/2, 1/3, 2, 2/3, 3, 1/2/3)