Panasonic AG-3DP1G - Manual (Page 113)

113
Chapter

Men
u
Oper
ations
SW MODE Screen
Item Setting Notes
LOW GAIN Sets the gain value assigned to the L position of the
GAIN switch.
0dB, 3dB, 6dB, 9dB, 12dB
MID GAIN Sets the gain value assigned to the M position of the
GAIN switch.
0dB, 3dB, 6dB, 9dB, 12dB
HIGH GAIN Sets the gain value assigned to the H position of the
GAIN switch.
0dB, 3dB, 6dB, 9dB, 12dB
USER MAIN Sets the function assigned to the USER MAIN button.
PUSH AF, Y-GET, SHOT MARK, REC CHECK,
R CONV, 3D A.Z WFM, 3D A.ALERT, 3D A.CONV.
For details, refer to [Assigning Functions to USER
Buttons] (page 50).
USER1 Sets a function assigned to the USER1 button. The
functions that can be assigned to this button are the
same as for the USER MAIN button.
Y-GET
For details, refer to [Assigning Functions to USER
Buttons] (page 50).
USER2 Sets a function assigned to the USER2 button.
PUSH AF, Y-GET, SHOT MARK, REC CHECK, 3D A.Z
WFM, 3D A.ALERT, 3D A.CONV.
For details, refer to [Assigning Functions to USER
Buttons] (page 50).
RET Sets the function assigned to the RET button on the
lens.
REC CHECK, RETURN
LCD/EVF Sets the images on the LCD monitor and in the
viewfinder that you can select by pressing the LCD/
EVF button.
MIX:
Normal image (left-lens image) or MIX image
MIX/R:
Normal image, MIX image or right-lens image
ALL: Normal image, MIX image, right-lens image or
Side by Side image
• The normal image (left-lens image) is displayed
immediately after the unit is turned on or when
normal playback is performed.
RECORDING SETUP Screen
Item Setting Notes
REC FUNCTION Sets special recording modes.
NORMAL:
The special recording modes are not used.
INTERVAL:
Sets interval recording.
• This function is always set to NORMAL when the
power is turned on.
• This item is not available when native
recording is selected in REC FORMAT.
INTERVAL TIME Sets the time interval of interval recording.
2frm, 4frm, 8frm, 16frm, 1s, 2s, 5s, 10s, 30s, 1min,
5min, 10min
For details, refer to [Interval Recording (INTERVAL
REC)] (page 40).
• Available only when REC FUNCTION
is set to INTERVAL.
____ indicates the factory setting