Panasonic AG-3DP1G - Manual (Page 114)

114
Chapter

Men
u
Oper
ations
Item Setting Notes
TC MODE Sets count correction when using the internal time
code generator.
DF:
Drop frame time code
NDF:
Non drop frame time code
For details, refer to [Setting the Time Code] (page 63).
• This item is not available when
SYSTEM MODE is set to 50 Hz.
It cannot be set and the item is
displayed in blue when SYSTEM
MODE is set to 23.98 Hz and REC
FORMAT is 24PN. In both cases, the
count correction is fixed to NDF.
UB MODE Sets the data recorded in the camera user bits.
USER, TIME, DATE, EXT, TCG, FRM.RATE
For details, refer to [Setting User Bits] (page 61).
AUDIO SETUP Screen
Item Setting Notes
FRONT VR CH1 Enables/disables the F. AUDIO LEVEL control of CH1
input.
FRONT:
Enables the F. AUDIO LEVEL control of
microphone input to CH1.
W.L.: Enables the F. AUDIO LEVEL control of audio
from a wireless receiver input to CH1.
REAR:
Enables the F. AUDIO LEVEL control of rear
input that is input to CH1.
ALL: Enables the F. AUDIO LEVEL control when front,
wireless, rear and other inputs are input to CH1.
OFF:
Disables the F. AUDIO LEVEL control of CH1.
• When the AUDIO SELECT CH1 switch
is set to AUTO and auto adjustment
mode is active, the the F. AUDIO
LEVEL control is disabled regardless
of these settings.
FRONT VR CH2 Enables/disables the F. AUDIO LEVEL control of CH2
input.
Same setting as FRONT VR CH1.
OFF
• When the AUDIO SELECT CH2 switch
is set to AUTO and auto adjustment
mode is active, the F. AUDIO LEVEL
control is disabled regardless of these
settings.
MIC LOWCUT CH1
* 1 Sets the CH1 microphone low-cut filter.
FRONT:
Operates for the front microphone input.
W.L.:
Operates for wireless receiver input.
REAR:
Operates for the rear microphone input.
OFF:
Turns off the filter for all inputs.
MIC LOWCUT CH2
* 1 Sets the CH2 microphone low-cut filter.
Same setting as MIC LOWCUT CH1.
OFF
MIC LOWCUT CH3
* 1 Sets the CH3 microphone low-cut filter.
Same setting as MIC LOWCUT CH1.
OFF
MIC LOWCUT CH4 * 1 Sets the CH4 microphone low-cut filter.
Same setting as MIC LOWCUT CH1.
OFF
LIMITER CH1 Sets the CH1 limiter.
ON, OFF
• When the AUDIO SELECT CH1 switch
is set to AUTO and auto adjustment
mode is active, the limiter is disabled
regardless of these settings.
LIMITER CH2 Sets the CH2 limiter.
ON, OFF
• When the AUDIO SELECT CH2 switch
is set to AUTO and auto adjustment
mode is active, the limiter is disabled
regardless of these settings.
* 1 The frequency characteristics for a microphone low-cut filter is 200 Hz – 10 kHz.
____ indicates the factory setting