Pitney Bowes 1630 - Manual (Page 108)

16 - 2 I M P O R T A N T I N F O R M A T I O N
Your telephone company may make changes to its facilities, equipment,
operations or procedures that could affect the proper functioning of your
equipment. If they do, you will be notified in advance to give you an
opportunity to maintain uninterrupted telephone service.
If you experience trouble with your machine, please contact the Diagnostic
Center for information on service or repair. The telephone company may
ask that you disconnect this equipment from the line until the problem has
been corrected or until you are sure that the equipment is not
malfunctioning.
Pitney Bowes Diagnostic Center
If you have questions regarding your 1630 or to request service, call* the
Pitney Bowes Diagnostic Center at 1-800-243-5556. In the U.S., you can
also fax a request for information to the Diagnostic Center at 800-824-
4417. In Canada, please call the Canadian Pitney Bowes Diagnostic
Center at toll free 800-668-9194 (English); or 800-387-0185 (French). In
the U.K., call 01279-443431. In Australia, call your local office.
*Important: When calling, please use the 1630 telephone handset or a
phone within reach of the machine. Why? A Pitney Bowes technician can
more easily assist you when reviewing the machine status and/or settings.
WARNING
To protect against risk of electrical shock, always disconnect all cables
from wall outlets before servicing, modifying or installing the equipment.
Use of controls, adjustments or performance of procedures other than
those specified in this manual may result in hazardous invisible radiation
exposure.
This equipment may not be used on coin service lines provided by the
telephone company or connected to party lines.
Federal Communications Commission (FCC)
Declaration of Conformity (For USA Only)
Responsible Party : Pitney Bowes
100 Oakview Drive
Trumbull, CT 06611
TEL : (800) 290-7860
declares, that the products
Product Name : 1630
comply with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.