Pitney Bowes 1630 - Manual (Page 53)

T X S E T T I N G S 6 - 1
6 6
Before You Begin
n Documents must be between 5.8 and 8.5 inches wide, and 3.9 and 14.1
inches long. Your machine can scan an image only 8.15 inches wide,
regardless of how wide the paper is.
n Make sure you insert documents face down, top edge first.
n Adjust the paper guides
to fit the width of your
document.
n The ADF (automatic document feeder) can hold up to 30 pages, feeding
each one individually through the machine. Use standard (17 lb–24 lb)
paper when using the ADF. If you’re using heavier paper, feed each sheet
individually to prevent paper jams.
n The ADF can hold up to 50 pages if you stagger the pages and meet the
following conditions:
Temperature: 68°F – 86°F (20°C – 30°C)
Humidity: 50% – 70%
Paper: Xerox 4200 (20LB/LTR),
Fan the paper, then stagger
the pages in the document
feeder as shown below:
DO NOT use curled, wrinkled, folded or ripped paper, or paper with
staples, paper clips, paste or tape attached. DO NOT use cardboard,
newspaper or fabric.
n Make sure documents written in ink are completely dry.
n Press Mode (before you send the fax) to select the resolution for the
document you’re sending. (See Resolution, page 6-8.)
TX Settings