Pitney Bowes 1630 - Manual (Page 78)

R E M O T E F A X O P T I O N S 9 - 4
Remote Commands
Follow the commands below to access features remotely. When you call
your machine and enter your Remote Retrieval Passcode (1 5 9
), the
system will signal you with two short beeps to enter a remote command.
Remote Commands
95 Changing Fax Forwarding/
Paging setting
1 OFF
2 Fax Forwarding
3 Paging
4 FAX FWD No.
6 Remote Rtrv ON
7 Remote Rtrv OFF
Operation Details
96 Retrieve a fax
1 Jobs Report
2 Retrieve all faxes
3 Erase fax from
the memory
If you hear one long beep, the change is
accepted. If you hear three short beeps, you
cannot change it because the conditions have
not been met. (Example: registering paging
number). You can register your fax
forwarding number by using 4. FAX FWD
NO (see page 9-6). Once you have registered
the number, your machine will change
automatically to FAX FWD:ON mode. Then
retrieve a Jobs Report by entering 961 (see
page 9-6) to make sure that the Fax
Forwarding number you registered is correct
on the List.
You can set REMOTE RTRV to ON or OFF.
Enter the number of a remote fax machine to
receive the Jobs Report List or stored fax
message(s). (See page 9-5.)
If you hear one long beep, you can erase fax
message(s) from the memory.
97 Check the receiving status
1 Fax You can check whether your machine has
received any fax message(s). If yes, you will
hear one long beep. If no, you will hear three
short beeps.
98 Change Answer Mode
1 TAM
2 Fax/Telephone
3 Fax
If you hear one long beep, you can change the
Answer Mode. If you hear three short beeps,
you cannot change it.
90 Exit After a long beep, you can exit remote retrieval.