Pitney Bowes 1630 - Manual (Page 23)

A S S E M B L Y A N D C O N N E C T I O N S 2 - 11
Special Line Considerations
Roll Over Phone Lines
A roll over phone system is a group of two or more separate telephone
lines that pass incoming calls to each other if they are busy. The calls are
usually passed down or “rolled over” to the next available phone line in a
preset order.
Your machine can work in a roll over system as long as it is the last
number in the sequence, so the call cannot roll away. Do not put the
machine on any of the other numbers; when the other lines are busy and a
second fax call is received, the fax call would be transferred to a line that
does not have a fax machine. Your machine will work best on a dedicated
line.
Two-Line Phone System
A two-line phone system is nothing more than two separate phone
numbers on the same wall outlet. The two phone numbers can be on
separate jacks (RJ11) or combined into one jack (RJ14). Your machine
must be plugged into an RJ11 jack. RJ11 and RJ14 jacks may be equal in
size and appearance and both may contain four wires (black, red, green,
yellow). To test the type of jack, plug in a two-line phone and see if it can
access both lines. If it can, you must separate the line for your machine.
Converting Telephone Wall Outlets
There are three ways to convert to an RJ11 receptacle. The first two ways
may require assistance from the telephone company. You can change the
wall outlets from one RJ14 jack to two RJ11 jacks. Or, you can have an
RJ11 wall outlet installed and slave or jump one of the phone numbers to
it.
The third way is the easiest: Buy a triplex adapter. You can plug a triplex
adapter into an RJ14 outlet. It separates the wires into two separate RJ11
jacks (Line 1, Line 2) and a third RJ14 jack (Lines 1 and 2). If your
machine is on Line 1, plug the machine into L1 of the triplex adapter. If
your machine is on Line 2, plug it into L2 of the triplex adapter.
RJ14
RJ11
Triplex Adapter
RJ14