NETGEAR ProSafe WNDAP330 - Manual (Page 104)

ProSafe Dual Band Wireless Access Point WNDAP330 Reference Manual
4-12 Advanced Configuration
v1.0, May 2008
The other Bridge-mode Wireless Stations must be set to Point-to-Point Bridge mode, using the
MAC address of this WNDAP330. They then send all traffic to this “Master”, rather than
communicate directly with each other.
When you click the Edit button, you must enter the Profile Name and the MAC address
(physical address) of the other Bridge mode Wireless Station in the fields provided. WEP,
WPA-PSK, or WPA2-PSK are supported. WPA2-PSK can (and should) be used to protect this
communication.
• Repeater. If selected, this wireless access point will operate as a Repeater only, and send all
traffic to the remote access point.
When you click the Edit button, you must enter the Profile Name and the MAC address
(physical address) of the other Bridge mode Wireless Station in the fields provided. WEP,
WPA-PSK, or WPA2-PSK are supported. WPA2-PSK can (and should) be used to protect this
communication.
The screens used to configure these options are located by selecting Wireless Bridge on the main
menu under the Configuration tab (see
Figure 4-6 below).
Note: This option does not support communication with Wireless clients, that is,
Client cannot associate to the AP when it is operating as a Repeater.