NETGEAR ProSafe WNDAP330 - Manual (Page 93)

4-1
v1.0, May 2008
Chapter 4
Advanced Configuration
This chapter describes how to configure the advanced features of your ProSafe 802.11n Dual Band
Wireless Access Point WNDAP330. The advanced configuration features are located under
various sub-menus under Configuration and provide the following functions:
• IP Settings. Using the wireless access point as a DHCP server for wireless clients.
• Hotspot settings. Enabling HTTP redirect.
• Wireless Settings: Configuring advanced wireless LAN parameters.
• Access Point Settings: Enabling wireless bridge and repeater modes.
IP Settings for Wireless Clients
You can turn this access point into a DHCP Server for wireless clients for both DHCP-enabled
wireless clients as well as for static-IP enabled clients. The default advanced IP wireless settings
usually work well. This feature is intended for use by a systems administrator. By default, this
feature is not enabled.
To use this wireless access point as a DHCP server:
1. From the main menu under Configuration, select IP, and then select DHCP Server Settings.
The DHCP Server Settings screen will display.
2. DHCP Server is disabled by default, as shown in Figure 4-1 . Select the Enable radio button to
enable this wireless access point as a DHCP server.