NETGEAR ProSafe WNDAP330 - Manual (Page 71)

3-1
v1.0, May 2008
Chapter 3
Management
This chapter describes how to use the management features of your ProSafe 802.11n Dual Band
Wireless Access Point WNDAP330. To access these features, connect to the WNDAP330 as
described in
“Logging In Using the Default IP Address” on page 2-12 . Then select the category
under either the Management or Information headings in the main menu of the browser interface.
Remote Management
Both the SNMP and Remote Console are enabled by default, which allows for remote
management of the WNDAP330 from a client running SNMP management software, as well as
from a secure Telnet console.
To set up an SNMP management interface:
1. Under the Maintenance tab, select Remote Management, and then select SNMP from the left-
hand menu. The SNMP screen will display, as shown in Figure 3-1 .
Figure 3-1