NETGEAR ProSafe WNDAP330 - Manual (Page 99)

ProSafe Dual Band Wireless Access Point WNDAP330 Reference Manual
Advanced Configuration 4-7
v1.0, May 2008
• Beacon Interval (100 - 1000): The Beacon Interval. Specifies the interval time between
100ms and 1000ms for each beacon transmission, which allows the access point to
synchronize the wireless network. The default is 100.
• Aggregation Length (1024-65535) (11b/g only): The aggregation length defines the size
of aggregated packets. Larger aggregation lengths may sometimes lead to better network
performance. The default is 65535.
• AMPDU (11b/g only): Aggregated MAC Protocol Data Unit. Aggregates several MAC
frames into a single large frame to achieve higher throughput. The default is enabled.
• RIFS Transmission (11b/g only): Reduced Interframe Space. RIFS transmissions are
shorter than other interframe spaces, and if enabled allow transmission of successive
frames at different transmit powers. The default is disabled.
• DTIM Interval: The Delivery Traffic Indication Message. Specifies the data beacon rate
between 1 and 255. The default is 3.
• Preamble Type (11b/g only): A long transmit preamble may provide a more reliable
connection or a slightly longer range. A short transmit preamble gives better performance.
The Auto settings automatically handles both long and short preambles. The default is
Auto.
5. Click Apply to enable the Wireless Settings.
Configuring 802.11a/n Advanced Wireless Settings
To configure advanced Wireless Settings:
1. Under the Configuration tab, select Wireless.
2. From the left-hand menu, select Advanced, and then select Wireless Settings.