NETGEAR ProSafe WNDAP330 - Manual (Page 32)

ProSafe Dual Band Wireless Access Point WNDAP330 Reference Manual
2-6 Basic Installation and Configuration
v1.0, May 2008
4. Enter the Access Point Name of the WNDAP330.
This unique name is the access point NetBIOS name. The default Access Point Name is
located on the bottom label of WNDAP330. The default is netgearxxxxxx, where xxxxxx
represents the last 6 digits of the WNDAP330 MAC address. You may modify the default
name with a unique name up to 16 characters long.
5. From the Country/Region pull-down menu, select the region where the WNDAP330 can be
used (the default Country/Region is the United States).
Figure 2-3
Note: If your country or region is not listed, please check with Netgear Support.