NETGEAR ProSafe WNDAP330 - Manual (Page 36)

ProSafe Dual Band Wireless Access Point WNDAP330 Reference Manual
2-10 Basic Installation and Configuration
v1.0, May 2008
Configuring Wireless Access
To configure your wireless settings for 11b/g/n and 11a/n:
1. From the main menu under Configuration, select Wireless. The Wireless Settings screen will
display, as shown in Figure 2-7 .
2. Enter the wireless settings for your area. See the online help or “Wireless Settings” on
page 2-14 .
3. Click Apply to save your settings.
When you have completed the setup steps, you can deploy the WNDAP330 in your network. If
needed, you can now reconfigure the computer you used in step 1 (from the Static IP) back to its
original TCP/IP settings.
Deploying the WNDAP330 Wireless Access Point
To deploy the WNDAP330 Wireless Access Point:
1. Disconnect the WNDAP330 and position it where it will be deployed. The best location is
elevated, such as wall mounted or on the top of a cubicle, at the center of your wireless
coverage area, and within line of sight of all the mobile devices.
2. Lift the antenna on either side so that they are vertical.
Figure 2-7
Note: Refer to the antenna positioning and wireless mode configuration information
in the Advanced Configuration chapter of the Reference Manual.