NETGEAR ProSafe WNDAP330 - Manual (Page 84)

ProSafe Dual Band Wireless Access Point WNDAP330 Reference Manual
3-14 Management
v1.0, May 2008
Under the Monitoring tab, select System on the main menu to view the System screen, shown in
Figure 3-11 below. This screen shows the parameters listed in Table 3-1 :
Table 3-1. System Information Fields
Field Description
Access Point Information
Access Point Name Indicates the NetBIOS name. The default name may be changed, if desired.
MAC Address Displays the Media Access Control address (MAC address) of the wireless
access point’s Ethernet port.
Country/Region Displays the domain or region for which the wireless access point is
licensed for use. It may not be legal to operate this wireless access point in
a region other than one of those identified in this field.
Firmware Version The version of the firmware currently installed.
Access Point Mode Identifies the operating mode of the WNDAP330: Access Point, Point-to-
point bridge, Point-to-point bridge with Access Point, Multi-point bridge or
Repeater.
Current IP Settings
IP Address The IP address of the wireless access point.
Subnet Mask The subnet mask for the wireless access point.
Default Gateway The default gateway for the wireless access point communication.
DHCP Client Enabled indicates that the current IP address was obtained from a DHCP
server on your network. Disabled indicated a static IP configuration.
Current Wireless Settings for 802.11n/g
Operating Mode Identifies the 802.11 operating mode of the WNDAP330.
Channel/Frequency Identifies the channel the wireless port is using. 11 is the default channel
setting. (Channel frequencies used on each channel can be found in “Wire-
less Communications”; a link to this article is in
Appendix B, “Related
Documents” . ).
Rogue AP Detection Identifies whether the Rogue AP detection feature is enabled or disabled.