NETGEAR ProSafe WNDAP330 - Manual (Page 62)

ProSafe Dual Band Wireless Access Point WNDAP330 Reference Manual
2-36 Basic Installation and Configuration
v1.0, May 2008
Configuring WPA with RADIUS
Not all wireless adapters support WPA. Furthermore, client software is required on the client.
Windows XP and Windows 2000 with Service Pack 3 or above do include the client software that
supports WPA. Nevertheless, the wireless adapter hardware and driver must also support WPA.
Consult the product document for your wireless adapter and WPA client software for instructions
on configuring WPA settings.
To configure WPA, follow these steps:
1. Under the Configuration tab, select Security on the main menu, select Advanced from the left-
hand menu, and then select RADIUS Server Settings. The RADIUS Server Settings screen
will display.
2. Enter the RADIUS Server Settings as shown in “Configuring the RADIUS Server Settings” on
page 2-30 .
3. Click Apply to save your RADIUS Server settings.
4. Under the Configuration tab, select Security from the main menu, and then select either
Security Profile Settings for 802.11b/g/n or 802.11a/n. The screen for the Profile Settings you
selected will display. When the Security Profile screen displays, check the radio button of the
Security Profile you want to modify and click Edit.
Note: If you use a wireless computer to configure WEP settings, you will be
disconnected when you click Apply. Reconfigure your wireless adapter to match
the new settings or access the wireless access point from a wired computer to
make any further changes.
Figure 2-18