Cli commands, Cli commands -4 – NETGEAR ProSafe WNDAP330 User Manual
Page 74
Advertising
ProSafe Dual Band Wireless Access Point WNDAP330 Reference Manual
3-4
Management
v1.0, May 2008
•
Baud rate: 9600 bps
•
Data bits: 8
•
Parity: none
•
Stop bit: 1
•
Flow control: none
These settings appear below the connector on the back panel.
3. Press Enter. The screen shown below in
should appear.
4. Enter the login name and password (admin and password are the defaults).
After successful login, the <Access Point Name> prompt should appear. In this example, the
prompt is netgear74F35E.
5. Enter
help
to display the CLI command help.
CLI Commands
The CLI commands are listed in
Appendix C, “Command Line Reference
Figure 3-3
Advertising