Appendix a. factory default configuration – Nortel Networks LIP-6830 User Manual
Page 103
LIP-6812 & LIP-6830
Installer Guide
Rev.01.04 A-1
June
07
Appendix A. Factory Default Configuration
Factory default configurations are settings for the configuration which are set at the factory. The
default values for configurable settings are given in Table A below.
Config File
Section Name
Parameter/Field
Default Value
Network Mode
DHCP
IP Address
192.168.1.1
Subnet Mask
255.255.255.0
Default Gateway
192.168.1.254
Primary DNS Address
0.0.0.0
Secondary DNS Address
0.0.0.0
Domain Name*
Not Assigned
TFTP Server address
Not Assigned
TOS (Type of Service)*
0
PC port VLAN Priority
3
PC Port VLAN Id
0
LAN port VLAN Priority
5
[LAN]
LAN port VLAN Id
0
Call Server Address line 1
0.0.0.0
Proxy Port line 1
5060
Display Name line 1
Not Assigned
Name line 1
Not Assigned
Auth. Username line 1
Not Assigned
Auth. Password line 1
Not Assigned
Line 1 Line type
Private
Extension for DSS line 1
Not assigned
Call Server Address line 2
0.0.0.0
Proxy Port line 2
5060
Display Name line 2
Not Assigned
Name line 2
Not Assigned
Auth. Username line 2
Not Assigned
Auth. Password line 2
Not Assigned
Line 2 Line type
Private
Extension for DSS line 2
Not assigned
Outbound Proxy Address
Not Assigned
Outbound Proxy Port
5060
Backup Proxy Address
Not Assigned
Backup Proxy Port
5060
Domain* Not
assigned
Start RTP Port
23000
VMS Address
Not Assigned
prack mode**
disabled
User Name*
Not Assigned
Replaces header**
enabled
[VOIP]
Local UDP Port
5060