Nortel Networks LIP-6830 - Manual (Page 116)

LIP-6812 & LIP-6830 Installer Guide
Rev. 01.04 D- 8 June 07
jitterbuffer_min_delay
(Optional) Minimum jitter buffer delay time in milliseconds.
Valid values are 0 to 150.
Default is 30.
Note : Jitter buffer is used to control QoS. Using larger values
produce less packet loss as the LIP Phone will wait longer for
receipt of packets. However, large values may delay voice
packet processing. Smaller values may produce more packet
loss but quicker voice packet processing.
jitterbuffer_nom_delay
(Optional) Nominal jitter buffer delay time in milliseconds.
Valid values are 0 to 150.
Default is 60.
jitterbuffer_max_delay
(Optional) Maximum jitter buffer delay time in milliseconds.
Valid values are 0 to 150.
Default is 120.
condition
(Optional) Specifies the condition when the phone forwards a
call.
Valid values are as follows:
•
-1 — disabled (Disable forwarding feature)
• 0 — not-usage (Don’t forward a call)
• 1— no-answer (Forward a call when the call is not
answered).
• 2 — busy (Forward a call when the phone is busy).
• 3 — no-answer & busy (Forward a call when the phone is
busy or the call is not answered).
• 4 — un-conditional (Always forward a call).
Default is 0 (not-usage).
forwarding_address
(Optional) Specifies the address to forward a call.
Max 60 characters are available.
FWRD
noanswer_time
(Optional) Specifies the no-answer time, in seconds, for no-
answer condition forward.
Valid values are 1 to 30.
Default is 10.
dial_mode
(Optional) Specifies the default dial-mode.
Valid values are number, ip or url.
Default is number.
pause_timer
(Optional) Specifies the pause timer in seconds.
Valid values are 1 to 30.
Default is 3.
inter_digit_timer
(Optional) Specifies the inter-digit timer in seconds.
Valid values are 1 to 30.
Default is 6.
dialplan
(Optional) Specifies the dial plan type.
Valid values are digitmap or routing.
Default is routing.
digitmap
(Optional) Specifies the digit map string.
Max 512 characters are available.
Default is “x.T|x+#”.
digitmap_tone
(Optional) Specifies the digit map string for second dial tone.
Max 512 characters are available.
DIAL
digitmap_process
(Optional) Specifies the digit map string with truncation, prefix
and post digits.
•
num: the digitmap string (max. 512 length string)
• trunc: the number of digits to strip (max string 0 ~ 30)
• prefix: the digits to add in the front of truncated number
(max. 32 length string)
• post: digits to add at the end of truncated number.
(max. 32 length string)