Nortel Networks LIP-6830 - Manual (Page 114)

LIP-6812 & LIP-6830 Installer Guide
Rev. 01.04 D- 6 June 07
linen_password a registration is challenged by the proxy server during
initialization.
The n variable represents a phone line.
Max 50 characters are available.
line1_type ~
linen_type
(Optional) Line type can be configured by ITSPs.
Valid values are as follows:
•
private — A line that is only presented with any call
appearance that is only visible and accessible through the
original endpoints involved in setting up the call.
•
shared — a line that is only presented with any call
appearance that is visible and optionally accessible through
the original endpoints in the call as well as an authorized set
of other endpoints in the network.
•
dss — a shared line except no outgoing call access is
provided. The users can make one-touch calling to covered
extensions (Direct Station Selection).
The externsion number is set in the linen_extension field.
Default is private.
line1_extension ~
linen_extension
(Optional) When a line (linen_type) is assigned as a DSS,
the associated extension number must be assigned.
The n variable represents a phone line.
Note : (Optional) Routing table can be used to manage the dial plan in the
LIP Phone. As soon as a digit pattern matching the routing table entry is
found, the call setup process will complete automatically.
Note: 0 to 9, ‘*’ and ‘#’ defines the prefix digits and the number of digits
required to follow each prefix
‘~’ is a wild card character that match any multiple characters.
‘?’ is a wild card character that match any 1 character.
‘.’ represents “virtual dial tone”
‘,’ locates the position of a 3-second pause in the prefix number
intf Must be SIP.
port Must be 0.
nums
Specifies the destination prefix number.
Valid values are 0 to 9, ‘*’, ‘#’, ‘~’, ‘?’, ‘.’ or NULL.
trunc
(Optional) Specifies the number of prefix digits to be stripped
before forwarding the collected digits to the destination. Valid
values are 0 to 31.
pre
(Optional) Specifies the number to add in front of the phone
number. Valid values are 0 to 9, ‘*’, ‘#’, ‘.’, ‘~’ or NULL.
post
(Optional) Specifies the number to add at the back of the
phone number. Valid values are 0 to 9, ‘*’, ‘#’, ‘.’, ‘~’ or NULL.
pause
(Optional) Specifies the position of prefix table which has the 3
seconds pause before sending the call. The ‘,’ locates the
position of the 3 seconds pause in the prefix number. Valid
values are ‘?’, ‘,’ or NULL.
ROUTE add
ip-addr
(Optional) Specifies the ip-address of phone to assign the
prefix number without regard to the proxy address..
ringer_off
(Optional) Turn on or off the ring signal when receiving
inbound call.
Valid values are 1 (on) and 0 (off).
Default is 1 (on).
VAD
(Optional) Enables voice activation detection (VAD).
Valid values are on and off.
Default is off.
dtmf_payload
(Optional) Specifies the DTMF payload type for RFC2833.
Valid values are 96 through 255. The default is 101.
DSP
dtmf_duration
(Optional) Specifies the DTMF duration.