Nortel Networks LIP-6830 - Manual (Page 20)

LIP-6812 & LIP-6830 Installer Guide
Rev 01.04 14 June 07
3.4 Network Configuration
Under Network Configuration, the IP Network settings, Dynamic Host Control Protocol
(DHCP) mode, IP addresses, DNS (Domain Name Service), etc. can be viewed and changed.
In addition, the LIP-6812 & LIP-6830 MAC address can be viewed. When Static IP addressing
is employed on the LAN, the IP Network settings must be configured manually; the settings
include:
- IP Address
- Default Gateway (router) IP Address
- Subnet Mask
Changing Network parameters requires a reboot of the LIP Phone; when you exit the
LCD Menu, you will receive a Reboot notice.
3.4.1 Network
Mode
The IP Phone is capable of obtaining all of its IP configuration data from a DHCP server. When
Static addressing is employed for the Network mode, the following network parameters must be
defined:
- IP address of the phone
- Default Gateway (router) IP Address
- Subnet Mask
- DNS Address
To set the Static addressing mode:
1) Press the button. If the LCD Menu is locked, use the unlock procedure (refer to
Section 3.3 Lock/Unlock Configuration).
2) Press button, or move cursor to 1.Network Configuration using [Next]/[Prev] Softkeys,
and press the [ OK ] Softkey.
3) Press button, or move cursor to 1.Network Mode using [Next]/[Prev] Softkeys, and
press the [ OK ] Softkey.
4) Choose the Network Mode using [Next]/[Prev] Softkeys, and press the [ OK ] Softkey to
save your selection.
5) Press the button to exit from the menu.
An asterisk » is displayed in front of the current selection.
Changing the Network Mode requires a reboot of the LIP Phone; when you leave the
menu, you will receive a Reboot notice.
Network Mode
*Static
[Next] [ OK ]