Nortel Networks LIP-6830 - Manual (Page 36)

LIP-6812 & LIP-6830 Installer Guide
Rev 01.04 30 June 07
To enter alpha-numeric characters select the [Mode] Softkey (refer to Appendix E. for
the character mapping of Dial pad digits).
Changing the Outbound Proxy Address requires a reboot of the LIP-6812/LIP-6830;
when you leave the menu, you will receive a Reboot notice.
3.5.2.2 Outbound Proxy Port
When an Outbound Proxy Server is defined, the associated Port must be defined as the
Outbound Proxy Port. All SIP requests will be sent to the assigned port instead of the Proxy
Port configured in Section 3.5.1.2.
To assign the Outbound Proxy Port:
1) Press the button. If the LCD Menu is locked, use the unlock procedure (refer to
Section 3.3 Lock/Unlock Configuration).
2) Press button, or move cursor to 2.SIP Configuration using the [Next]/[Prev] Softkeys,
and press the [ OK ] Softkey.
3) Press button, or move cursor to 4.Outbound Proxy Port using the [Next]/[Prev]
Softkeys, and press the [ OK ] Softkey.
4) Input the Outbound Proxy Port for the LIP-6812/LIP-6830 using the Dial pad.
5) Press
the [ OK ] Softkey to save your Configuration.
6) Press the button to exit from the menu.
Changing the Outbound Proxy Port requires a reboot of the LIP-6812/LIP-6830; when
you leave the menu, you will receive a Reboot notice.
3.5.2.3 Backup Proxy Address
When an Outbound Proxy is employed to receive SIP requests, a backup Proxy server can be
defined for use should the primary proxy fail to respond; the Backup Proxy Address can be
defined as an IP address or a FQDN.
To assign a Backup Proxy Address:
1) Press the button. If the LCD Menu is locked, use the unlock procedure (refer to
Section 3.3 Lock/Unlock Configuration).
2) Press button, or move cursor to 2.SIP Configuration using the [Next]/[Prev] Softkeys,
and press the [ OK ] Softkey.
Outbound Proxy Port
5060
[ » ] [CLR ] [ OK ]