NCR S26 - Manual (Page 117)

System Error Messages
NCR S26 Hot Plug Server User Guide B-5
Message Action
Memory error at:
MMMM:SSSS:OOO
(W:XXXX,R:YYYY)
where M is MB, S is
Segment, O is Offset, X/Y is
write/read pattern
Check SIMMs on the system board. Contact
your dealer.
Memory Size Mismatch
CPU Clock Mismatch
Run Setup. Check if the values shown in the
memory parameters are correct. If correct, exit
Setup and reboot the system. If the error
message reappears, seek technical assistance.
Onboard serial port 1 conflict Run Setup and disable the port.
Onboard serial port 2 conflict Run Setup and disable the port.
Onboard parallel port conflict Run Setup and disable the port.
Pointing device error Check and connect pointing device.
Pointing device interface error Replace the pointing device or contact your
dealer.
Press F1 key to continue or
Ctrl-Alt-Esc for setup Press F1 or Ctrl + Alt + Esc to enter Setup.
Real time clock error Check the RTC chip. If it is still good, run Setup.
If not, replace the RTC chip.