NCR S26 - Manual (Page 31)

Configuring the System Board
NCR S26 Hot Plug Server User Guide 2-13
The table below lists the system board jumpers and their corresponding
settings. The asterisks indicate the default settings. See Figure 2-8 for jumper
locations.
Table 2-1. Jumper Settings
Jumper Setting Function
JP1 1-2
2-3* Check Password
Bypass Password
JP2 2-3 Standard System BIOS
JP3 1-2
2-3* Terminator always set to ON
Use SCSI Setup Utility to set terminator to ON or OFF
JP4 1-2*
2-3 Wide SCSI
Standard
JP5 1-2
2-3* Hardware Reset Enabled
Hardware Reset Disabled
JP6 1-2*
2-3 Audio to Buzzer
Audio to Speaker
Connector Functions
The table below lists the different connectors on the system board and their
respective functions.
Table 2-2. Connector Functions
Connector Function
CN1 Power connector
CN2 Power connector
CN3 Backplane board HDD status connector
CN5 IDE hard disk connector
CN6 RDM connector
CN7 RDM connector
CN8 Diskette drive connector