NCR S26 - Manual (Page 126)

Sample Standard Configuration
C-8 Sample Configurations
– PCI slot 4 to --
– PCI slot 5 to --
– On Board VGA to 5
– On Board SCSI to IRQ 11
– VGA Palette Snoop to Disabled
– On Board SCSI to Enabled
– Boot Drive to Enabled
When you finish, the screen should look like the following:
PCI IRQ Setting [Manual]
INTA INTB INTC INTD
PCI Slot 1 [ 9] [10] [ 9] [11]
PCI Slot 2 [10] [ 9] [11] [ 5]
PCI Slot 3 [--] [--] [--] [--]
PCI Slot 4 [--] [--] [--] [--]
PCI Slot 5 [--] [--] [--] [--]
On Board VGA [5]
On Board SCSI [11]
VGA Palette Snoop [Disabled]
On Board SCSI [Enabled]
Boot Device [Enabled]
4. Press Esc to return to the main menu in BIOS Setup.
5. Press Esc, again. Select Yes to save System Settings and PCI Adapter
settings, and to reboot the system.
Configuring the SCSI Adapters and Drives
After configuring the System Settings and PCI Adapter settings using the
BIOS Setup Utility, the system reboots.