NCR S26 - Manual (Page 121)

Sample Standard Configuration
NCR S26 Hot Plug Server User Guide C-3
Sample Standard Configuration
A standard configuration might consist of the following:
•
Pentium 166 MHz processor
•
32 MB system memory
•
PCI Ethernet adapter (SMC8432BTA)
•
PCI Token Ring adapter (Olicom OC-3136)
•
2 GB SCSI Fast and Wide disk drive connected to the integrated Adaptec
7880 PCI SCSI controller
•
SCSI CD-ROM drive connected to the integrated Adaptec 7880 PCI
SCSI controller
Following are the steps to install and configure this sample configuration.
Installing the Hardware
To install the hardware, follow these steps:
1. Strap the 2 GB SCSI disk drive as SCSI ID 0 and the SCSI CD-ROM
drive as SCSI ID 5. (See the documentation that came with your drives
for strapping information.)
2. Install the 2 GB SCSI disk drive in a hot plug carrier and install in the top
hot plug bay.
3. Install the SCSI CD-ROM drive in the top front drive bay.
4. Connect power cables and SCSI cables to the SCSI CD-ROM drive. A
Fast/Wide SCSI cable should already be connected from the Adaptec
controller on the baseboard to the hot plug backplane.
5. Install the memory SIMMs in bank 1 on the system baseboard (installed
in groups of two SIMMs).
6. Install the PCI Ethernet Adapter in PCI slot 1 (topmost PCI slot).