NCR S26 - Manual (Page 125)

Sample Standard Configuration
NCR S26 Hot Plug Server User Guide C-7
On Board PS/2 Mouse (IRQ 12) [Enabled]
Setup Password [None]
Power On Password [None]
2. Press Esc to return to the main menu in BIOS Setup.
Configuring the PCI Adapters
To configure the PCI adapters, follow these steps:
1. Select PCI System Configuration from the main menu in BIOS Setup.
2. Change the PCI IRQ Setting to [Manual]. Then use the up and down
arrow keys to select the PCI slot number. Use the right and left arrow
keys to change the IRQ Level for INTA Pin settings.
– Available IRQ settings for primary PCI Bus (Slots 1 and 2, video,
and SCSI) are 3, 4 ,5, 7, 9, 10, 11, 14, and 15.
– Available IRQ settings for secondary PCI Bus (Slots 3, 4, and 5) are
4, 9, 10, 11, 14, and 15.
– To make IRQ 3 available for selection, you must disable Serial Port 2
in the System Security menu.
– To make IRQ 4 available for selection, you must disable Serial Port 1
in the System Security menu.
– To make IRQ 7 available for selection, you must disable Parallel Port
1 in the System Security menu.
– To make IRQ 14 available for selection, you must disable On Board
IDE in the Basic System Configuration menu.
3. Make the following settings:
– PCI IRQ Setting to Manual
– PCI slot 1 (PCI Ethernet Adapter SMC8432BTA) to IRQ 9
– PCI slot 2 (PCI Token Ring Adapter Olicom OC-3136) to IRQ 10
– PCI slot 3 to --