NCR S26 - Manual (Page 136)

Sample RAID Configuration
C-18 Sample Configurations
– On Board SCSI to IRQ 11
– VGA Palette Snoop to Disabled
– On Board SCSI AIC-7880 to Enabled
– Boot Device to Disabled
When you finish, the screen should look like the following:
PCI IRQ Setting [Manual]
INTA INTB INTC INTD
PCI Slot 1 [14] [10] [5] [11]
PCI Slot 2 [10] [5] [11] [14]
PCI Slot 3 [ 9] [--] [--] [10]
PCI Slot 4 [--] [--] [10] [ 9]
PCI Slot 5 [--] [10] [ 9] [--]
On Board VGA [5]
On Board SCSI [11]
VGA Palette Snoop [Disabled]
On Board SCSI [Enabled]
Boot Device [Disabled]
4. Press Esc to return to the main menu in BIOS Setup.
5. Press Esc again. Select Yes to save System Settings and PCI Adapter
settings and to reboot the system.
Configuring the SCSI Adapters and Drives
After configuring the System Settings and PCI Adapter settings using the
BIOS Setup Utility, the system reboots.
To configure the SCSI adapters and drivers, if connected to an Adaptec SCSI
adapter, follow these steps:
1. Press Ctrl + A when the following displays: