NCR S26 - Manual (Page 122)

Sample Standard Configuration
C-4 Sample Configurations
7. Install the PCI Token Ring Adapter in PCI slot 2 (below the PCI Ethernet
adapter).
Configuring the System Settings
To configure the system settings in the BIOS Setup Utility, follow these steps:
1. Turn on power to the system. Observe that the memory test is executed
(memory addresses should be rapidly displayed in upper left-hand corner
of screen). Ignore any memory size mismatch error displayed on the
screen.
2. Press Ctrl + Alt + Esc when prompted to enter the BIOS Setup Utility.
3. Select Load System Defaults and press Enter.
Basic System Configuration
1. Select Basic System Configuration. To go from page to page, press Page
Down or Page Up.
2. Go to page 2 and set parameters as follows (in the order indicated):
Fast Boot Mode [Disabled]
Auto Configuration Mode [Disabled]
Memory Test [Disabled]
Num Lock After Boot [Enabled]
Large Memory Support [Advanced]
On Board IDE [Disabled]
Hard Disk Size > 504 MB [Disabled]
Hard Disk Block Mode [Disabled]
3. Return to page 1, and set parameters as follows:
Diskette Drive A [1.44 MB 3.5-inch]
Diskette Drive B [None]