NCR S26 - Manual (Page 139)

Sample RAID Configuration
NCR S26 Hot Plug Server User Guide C-21
2. Select NCR 3426 Dual Pentium Pro System from the Advanced
Configuration menu.
Note: Refer to Chapter 5 for instructions on configuring the memory
correctly.
The PCI Adapter IRQ values entered below do not set the IRQ level for
PCI Adapters.
Note: PCI Adapter IRQ settings are set in the BIOS Setup Utility. You
enter the IRQ settings in the EISA Configuration Utility so that the EISA
Configuration Utility does not assign IRQ values to EISA Adapters that
have already been used for PCI Adapters.
Make sure the parallel port and serial ports are configured the same way
as in the BIOS Setup Utility.
3. Configure the baseboard options as follows:
System BIOS Type [RAM BIOS Enabled]
System Processor [Pentium Pro at 200 MHz]
Special System Parts [Special System Parts]
EISA Reserved Devices [EISA Reserved Devices]
System Memory Function
Base System Memory [640K Base Mem]
8-16 MB System Memory [16 MB System Memory]
16-64 MB System Memory [Enabled]
Note: You should manually configure the system memory by enabling
appropriate memory ranges and using Ctrl + R to configure the memory site
within these memory ranges.
Mouse Port [Enabled]
Keyboard Port [Enabled]
Floppy Disk Controller [Enabled]
IDE HDD Interface [Disabled]
Parallel Port [Enabled as LPT1 (3BCh)]