NCR S26 - Manual (Page 99)

Using the EISA Configuration Utility
NCR S26 Hot Plug Server User Guide 5-9
Maintain System Configuration Diskette
The System Configuration diskette contains the Configuration Utility and
CFG files. When you run the utility to configure your computer, the
configuration information is stored in the computer’s nonvolatile memory and
in a system configuration information (SCI) file. This file is saved on the
System Configuration diskette.
Select “Maintain system configuration diskette” from the main menu to
display the screen, as shown in the figure below.
Figure 5-3. Maintain Configuration Diskette
Maintain System Configuration Diskette
Create a backup SCI file
Load a backup SCI file
Copy/update CFG files
Copy/update SCI files
Delete CFG files
Delete SCI files
Return to the main menu
Select = ENTER <Cancel = ESC>
Exit from this Utility
This selection exits the utility. The system reboots. If you do not have an
operating system installed on your hard disk, replace the system utilities
diskette in the diskette drive with an operating system diskette.
Note: All the ECU screens have a command bar at the bottom to guide you
through the utility.