Nortel Networks NN46120-104 - Manual (Page 160)

160 Troubleshooting the NVG
( new setup, continued)
Enter the old secret passphrase (it is used during
addition of new iSDs to the cluster):
<Enter the same secret passphrase as was used in the
former cluster.>
Re-enter to confirm:
6 Wait for the initial setup of the first ASA 310-FIPS in the
cluster to finish.
( new setup, continued) Initializing system......ok
Setup successful. Relogin to configure.
login:
7 Add an additional ASA 310-FIPS to the newly created
cluster by following the instructions on page
“Adding an ASA
310-FIPS to an Existing Cluster” (page 63) up to and including
Step 4 .
8 Transfer the cluster wrap key from the CODE-SO and
CODE-USER iKeys to card 0.
When asked to insert the CODE-SO and the CODE-USER
iKeys, make sure to use the same CODE iKeys as you did in
Step 3 and Step 4 .
( join setup, continued)
Verify that CODE-SO iKey (black) is inserted in card 0
(with flashing LED).
Hit enter when done.
Verify that HSM-USER iKey (blue) is inserted in card 0
(with flashing LED).
Hit enter when done.
Verify that CODE-USER iKey (black) is inserted in card 0
(with flashing LED).
Hit enter when done.
Wrap key successfully combined to card 0.
9 Transfer the cluster wrap key to card 1.
Nortel VPN Gateway
User Guide
NN46120-104 02.01 Standard
14 April 2008
Copyright © 2007-2008 Nortel Networks
.