Nortel Networks NN46120-104 - Manual (Page 68)

68 Initial Setup
( join setup, continued)
Verify that CODE-SO iKey (black) is inserted in card 1
(with flashing LED). <insert the same CODE-SO iKey that
you used in Step 5 >
Hit enter when done.
Verify that HSM-USER iKey (blue) is inserted in card 1
(with flashing LED).
Hit enter when done.
Verify that CODE-USER iKey (black) is inserted in card
1 (with flashing LED). <insert the same CODE-USER iKey
that you used in Step 5 >
Hit enter when done.
Wrap key successfully combined to card 1.
7 If you selected FIPS mode when installing the first ASA
310-FIPS in the cluster, provide the correct passphrase.
If you selected FIPS mode when installing the first ASA
310-FIPS in the cluster, you will also be asked to provide the
passphrase you defined at that time. If you selected Extended
Security mode, this step will not appear.
( join setup, continued)
Enter the secret passphrase (as given during
initialization of the first iSD in the cluster):
8 Wait until the Setup utility has finished.
( join setup, continued)
Setup successful.
login:
The setup utility is now finished. The ASA 310-FIPS that
has now been added to the cluster will automatically pick up
all configuration data from one of the already installed ASA
310-FIPS units in the cluster. After a short while you will get a
login prompt.
Note: After successfully having initialized the HSM cards,
you are automatically logged in to each HSM card as USER.
You can verify the current HSM card login status by using the
/info/hsm command. After a reboot has occurred (whether
intentionally invoked, or due to a power failure), you must
manually log in to the HSM cards for the ASA 310-FIPS
device to resume normal operations. For more information
about logging in to the HSM cards after a reboot, see
“An ASA
310-FIPS Stops Processing Traffic” (page 153) .
Nortel VPN Gateway
User Guide
NN46120-104 02.01 Standard
14 April 2008
Copyright © 2007-2008 Nortel Networks
.