Nortel Networks NN46120-104 User Manual
Page 45
Setting Up a Two-Armed Configuration
45
Enter network mask [255.255.255.0]: <Press ENTER if
correct>
Enter VLAN tag id (or zero for no VLAN) [0]: <VLAN tag
id or ENTER>
Specify the desired network mask for the host IP address on
the management interface or accept the suggested value by
pressing ENTER. If a connected router or switch attaches VLAN
tag IDs to incoming packets, specify the VLAN tag ID used.
5
Enter
yes
and press ENTER to continue with creating a
two-armed configuration.
Setup a two armed configuration (yes/no) [no]: yes
6
Specify a new port number for the traffic interface.
Enter port number for the traffic interface [1-4]: 2
The traffic (public) interface port number will automatically be
assigned to Interface 2.
7
Specify a host IP address on the traffic (public) interface.
Enter IP address for this machine (on traffic
interface): <IP address>
This IP address will be assigned to Interface 2 on the VPN
Gateway, that is, the public interface.
8
Enter network mask and VLAN tag ID.
Enter network mask [255.255.255.0]:
Enter VLAN tag id (or zero for no VLAN) [0]:
Specify the desired network mask for the host IP address on
the traffic interface or accept the suggested value by pressing
ENTER. If a connected router or switch attaches VLAN tag IDs
to incoming packets, specify the VLAN tag ID used.
9
Enter a default gateway address on the traffic interface.
Enter default gateway IP address (on the traffic
interface): <gateway IP address>
Specify a default gateway IP address that is within the same
network address range as the host IP address on the traffic
(public) interface.
Nortel VPN Gateway
User Guide
NN46120-104
02.01
Standard
14 April 2008
Copyright © 2007-2008 Nortel Networks
.