Nortel Networks NN46120-104 - Manual (Page 71)

Adding an ASA 310-FIPS to an Existing Cluster 71
login: boot
Password: ForgetMe
*** Reinstall Upgrade Procedure ***
If you proceed beyond this point, the active network
configuration will be reset, requiring a reboot to
restore any current settings. However, no permanent
changes will be done until the boot image has been
downloaded.
Continue (y/n)? [y]: <Press ENTER to continue>
2 Confirm the network port setting, and the IP network
settings.
(reinstall procedure, continued)
Select a network port (1-4, or i for info) [1]: <Press
ENTER if correct, or change to the port you are using for
network connectivity>
Enter VLAN tag id (or zero for no VLAN tag) [0]: <VLAN
tag id or ENTER>
Enter IP address for this iSD [192.168.128.185]:
<Press ENTER if the IP address displayed within square
brackets is correct.>
Enter network mask [255.255.255.0]: <Press ENTER if
correct.>
Enter gateway IP address [192.168.128.1]: <Press ENTER
if correct.>
Note: If the VPN Gateway has not been configured for
network access previously, or if you have deleted the VPN
Gateway from the cluster by using the
/boot/delete
command, you must provide information about network
settings such as interface port, IP address, network mask,
and gateway IP address. No suggested values related to
a previous configuration will be presented within square
brackets.
3 Select a download method, specify the server IP address,
and the boot image file name.
Nortel VPN Gateway
User Guide
NN46120-104 02.01 Standard
14 April 2008
Copyright © 2007-2008 Nortel Networks
.