Nortel Networks NN46120-104 - Manual (Page 46)

46 Initial Setup
10 Enter a Management IP address (MIP) on the management
interface.
Enter the Management IP (MIP) address: <IP address>
Making sure the MIP does not exist...ok
Trying to contact gateway...ok
Finally enter a unique Management IP address (MIP) that is
within the same network address range as the host IP address
on the management (private) interface.
Complete the new setup by following the instructions in the next
section, "Complete the New Setup".
--End--
Complete the New Setup
Step Action
1 Configure the time zone and NTP and DNS server settings.
If you don’t have access to the IP address of an NTP server
at this point, you can configure this item after the initial setup is
completed. See the "NTP Servers Configuration " section under
Configuration menu>System Configuration in the Command
Reference.
( new setup, continued)
Enter a timezone or ’select’ [select]: <Press ENTER to
select>
Select a continent or ocean: <Continent or ocean by
number>
Select a country: <Country by number>
Select a region: <Region by number, if applicable>
Selected timezone: <Suggested timezone, based on your
selections>
Enter the current date (YYYY-MM-DD) [2006-03-01]:
<Press ENTER if correct>
Enter the current time (HH:MM:SS) [09:26:16]: <Press
ENTER if correct>
Enter NTP server address (or blank to skip): <IP
address>
Enter DNS server address: <IP address>
2 Generate new SSH host keys and define a password for the
admin user.
Nortel VPN Gateway
User Guide
NN46120-104 02.01 Standard
14 April 2008
Copyright © 2007-2008 Nortel Networks
.