Nortel Networks NN46120-104 - Manual (Page 44)

44 Initial Setup
Complete the new setup by following the instructions in the
section “Complete the New Setup” (page 46) .
--End--
Setting Up a Two-Armed Configuration
In a two-armed configuration, two separate interfaces are configured on
the VPN Gateway, one private interface for NVG management and intranet
connections and one public interface for Internet connections. Also see
figure on
“Two-Armed Configuration” (page 39) .
Step Action
1 Choose new from the Setup menu.
[Setup Menu]
join - Join an existing iSD cluster
new - Initialize iSD as a new installation
boot - Boot menu
info - Information menu
exit - Exit [global command, always
available]
>> Setup# new
Setup will guide you through the initial configuration
of the iSD.
2 Configure the management interface port number.
Enter port number for the management interface [1-4]: 1
Specify the port you want to use for NVG management and other
private traffic between the VPN Gateway and the intranet. This
port will be assigned to the private interface (Interface 1).
3 Specify the host IP address for the current VPN Gateway.
Enter IP address for this machine (on management
interface): <IP address>
Specify a host IP address on the management (private) interface.
This IP address must be unique on the network and be within
the same network address range as the Management IP address
(see
Step 10 ). The management interface host IP address is
assigned to Interface 1.
4 Enter network mask and VLAN tag ID.
Nortel VPN Gateway
User Guide
NN46120-104 02.01 Standard
14 April 2008
Copyright © 2007-2008 Nortel Networks
.