Nortel Networks WEB OS 212777 - Manual (Page 157)

Web OS 10.0 Application Guide
Chapter 6: Server Load Balancing n 157
212777-A, February 2002
Configuring RTSP Load Balancing
Before configuring your Web switch for RTSP load balancing, do the following:
n
Enable Virtual Matrix Architecture (VMA)
n
Enable Direct Access Mode (DAM)
n
Disable port-based Bandwidth Management
n
Disable proxy IP addressing
1. To configure a virtual server for Layer 4 load balancing of RTSP, select rtsp or port
554 as a service for the virtual server.
2. To configure a virtual server for Layer 7 URL hashing of RTSP, select rtsp as a virtual
service and enable rtspslb .
This command enables URL hashing using the entire URL; however, any extension of the type
(.xxx) occurring at the end of the URL is omitted from
hash computation.
3. Apply and save your configuration.
>> # /cfg/slb/virt <virtual server number> /service rtsp
>> # /cfg/slb/virt 1/service rtsp/rtspslb hash|pattern|dis
>> Virtual Server 2 rtsp Service# apply
>> Virtual Server 2 rtsp Service# save