Nortel Networks WEB OS 212777 - Manual (Page 469)

Web OS 10.0 Application Guide
Chapter 17: Bandwidth Management n 469
212777-A, February 2002
6. Set the bandwidth policy for the contract.
Each BWM contract must be assigned a bandwidth policy.
7. Enable the BWM contract.
8. Create a filter that will be used to classify the frames for this contract and assign the
BWM contract to the filter.
The classification policy for this BWM contract is based on a filter configured to match ICMP
traffic. The contract will be applied to any frames that match this filter
9. On the switch, apply and verify the configuration.
Examine the resulting information. If any settings are incorrect, make the appropriate changes.
10. On the switch, save your new configuration changes.
11. On the switch, check the BWM information.
Check that all BWM contract parameters are set correctly. If necessary, make any appropriate
configuration changes and then check the information again.
>> BWM Contract 1# pol 1 (Assign policy 1 to BWM contract 1)
>> BWM Contract 1# ena (Enables this BWM contract)
>> BW Contract 1# /cfg/slb/filt 1/proto icmp (Define protocol affected by filter)
>> Filter 1# adv/icmp any (Set the ICMP message type)
>> Filter 1 Advanced# cont 1 (Assign BWM contract 1 to this filter)
>> Filter 1 Advanced# /cfg/slb/filt 1/ena (Enable this filter)
>> Filter 1# apply (Port and enable filtering)
>> Filter 1 Advanced# apply (Make your changes active)
>> Filter 1 Advanced# /cfg/bwm/cur (View current BWM settings)
>> Bandwidth Management# save (Save for restore after reboot)
>> Bandwidth Management# /info/bwm < contract number > (View BWM information)