Nortel Networks WEB OS 212777 - Manual (Page 95)

Web OS 10.0 Application Guide
Chapter 4: OSPF n 95
212777-A, February 2002
10. Attach the network interface to the backbone.
11. Attach the network interface to the stub area.
12. Configure host routes.
One host route is needed for each virtual server on Web switch 1. Since virtual server
10.10.10.1 is preferred for Web switch 1, its host route has a low cost. Because virtual server
10.10.10.2 is used as a backup in case Web switch 2 fails, its host route has a high cost.
13. Apply and save the configuration changes.
>> OSPF Area (index) 1 # ../if 1 (Select OSPF menu for IP interface 1)
>> OSPF Interface 1 # aindex 0 (Attach network to backbone index)
>> OSPF Interface 1 # enable (Enable the backbone interface)
>> OSPF Interface 1 # ../if 2 (Select OSPF menu for IP interface 2)
>> OSPF Interface 2 # aindex 1 (Attach network to stub area index)
>> OSPF Interface 2 # enable (Enable the stub area interface)
>> OSPF Interface 2 # ../host 1 (Select menu for host route 1)
>> OSPF Host Entry 1 # addr 10.10.10.1 (Set IP address same as virtual server 1)
>> OSPF Host Entry 1 # aindex 0 (Inject host route into backbone area)
>> OSPF Host Entry 1 # cost 1 (Set low cost for preferred path)
>> OSPF Host Entry 1 # enable (Enable the host route)
>> OSPF Host Entry 1 # ../host 2 (Select menu for host route 2)
>> OSPF Host Entry 2 # addr 10.10.10.2 (Set IP address same as virtual server 2)
>> OSPF Host Entry 2 # aindex 0 (Inject host route into backbone area)
>> OSPF Host Entry 2 # cost 100 (Set high cost for use as backup path)
>> OSPF Host Entry 2 # enable (Enable the host route)
>> OSPF Host Entry 2 # apply (Global command to apply all changes)
>> OSPF Host Entry 2 # save (Global command to save all changes)