Nortel Networks WEB OS 212777 - Manual (Page 83)

Web OS 10.0 Application Guide
Chapter 4: OSPF n 83
212777-A, February 2002
OSPF Configuration Examples
A summary of the basic steps for configuring OSPF on the Web switch is listed here. Detailed
instructions for each of the steps is covered in the following sections:
1. Configure IP interfaces.
One IP interface is required for each desired network (range of IP addresses) being assigned to
an OSPF area on the Web switch.
2. (Optional) Configure the router ID.
The router ID is required only when configuring virtual links on the Web switch.
3. Enable OSPF on the switch.
4. Define the OSPF areas.
5. Configure OSPF interface parameters.
IP interfaces are used for attaching networks to the various areas.
6. (Optional) Configure route summarization between OSPF areas.
7. (Optional) Configure virtual links.
8. (Optional) Configure host routes.